Section 2. Getting Ready To Sew Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety; Polarized Plug - Janome TB-12 Instruction Book

w
r
t
SECTION II. GETTING READY
e
TO SEW
Connecting Machine to Power Supply
q Power supply plug
w Power switch
e Outlet
r Machine socket
q
t Machine plug
Before connecting the power cord, make sure
the voltage and frequency shown on the ma-
chine conform to your electrical power.
1. Turn off the power switch w.
2. Insert the machine plug t into the machine
socket r.
3. Insert the power supply plug q into the outlet
e.
4. Turn on the power switch w to activate the
power and sewing light.

Before Using Your Sewing Machine

Before using your sewing machine for the first
time, place a waste fabric under the presser foot
and run the machine with thread for a few
minutes. Wipe away any oil which may appear.

For Your Safety

* While in operation, always keep your eyes on
the sewing area. Do not touch any moving
parts, such as the thread take-up lever,
handwheel or needle.
* Always turn off the power switch and unplug
from the power supply:
- When leaving the machine unattended
- When attaching or removing any parts
- When cleaning the machine
* Do not place anything on the foot control,
when not sewing.

Polarized plug

This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of an electric
shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not
modify the plug in any way.
Foot Controller Model YC-482J-1 or TJC-150 is used
with
Sewing Machine Model TB-12.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the
faster the machine runs.
6