Corded Buttonholes - Janome DC 3018 Instruction Book

q
1 2
q
3 4
5 6
w
w
e
Corded buttonhole
Machine Settings
q Pattern:
#16
w Presser foot:
Automatic buttonhole foot R
To sew a corded buttonhole, follow the same
procedure as for a sensor buttonhole.
1 With the automatic buttonhole foot R raised, hook
the filler cord on the spur on the back of the
buttonhole foot.
2 Bring the ends of cord toward you under the
buttonhole foot clearing the front end.
Hook the ends of the filler cord into the forks on
the front of the buttonhole foot to hold them tight.
q Spur
w Forks
e Cord
3 Lower the needle into the garment where the
buttonhole will start and lower the foot.
4 Lower the buttonhole lever and buttonhole foot.
Start the machine and sew the buttonhole over the
filler cord.
The machine stops automatically when finished.
NOTES:
Set the stitch width in accordance with the thickness
of the filler cord used.
To cut the buttonhole opening, refer to page 22.
5 Remove the fabric from the machine and cut the
sewing threads.
6 Pull the left end of the filler cord to tighten it.
Thread the end of the cord through a darning
needle and draw it to the wrong side of the fabric
and cut.
25