Troubleshooting; Fishing System Doesn't Power Up; Fishing System Defaults To Simulator With A Transducer Attached - Humminbird Platinum Cartography Accessories Manual

531598-1_A - PlatCart_Man.qxp

Troubleshooting

Before contacting the Humminbird® Customer Resource Center, please read
the following section. Taking the time to review these troubleshooting
guidelines may allow you to solve a performance problem yourself, and
therefore avoid sending your unit back for repair.

Fishing System Doesn't Power Up

If your Fishing System doesn't power up, use the Installation Guide that also
comes with it for specific confirmation details, making sure that:
• the power cable is properly connected to the Fishing System control
head,
• the power cable is wired correctly, with red to positive battery
terminal and black to negative terminal or ground
• the fuse is operational
• the battery voltage of the power connector is at least 10 Volts.
Correct any known problems, including removing corrosion from the battery
terminals or wiring, or actually replacing the battery if necessary.
4/11/2007 8:27 AM Page 20

Fishing System Defaults to Simulator with a Transducer Attached

A connected and functioning transducer will cause the newly-started
Fishing System to go into Normal operating mode automatically. If, when
you power up the Fishing System, it goes into Simulator mode automatically,
even though a transducer is already connected, this means that the control
head is not detecting the transducer. Perform the following troubleshooting
tasks:
• Using the Installation Guide that also comes with your Fishing
System, check to make sure that the transducer cable is securely
connected to the Fishing System. Reconnect if necessary, and power
up the Fishing System again to see if this fixes the problem.
• Replace the non-functioning transducer with a known good
transducer if available and power up the control head again.
• Check the transducer cable. Replace the transducer if the cable is
damaged or corroded.
20