Generac Power Systems 006180-0 Owner's Manual page 7

• ALWAYS make sure connections are made to the correct terminal. Damage due to reversed
polarity is not covered by warranty.
• NEVER connect or set up the power inverter or appliances while operating a vehicle. Not
paying attention to the road may result in a serious accident.
• NEVER plug the power inverter into a location that interferes with the vehicle controls (i.e.
near the gear shift lever).
• ALWAYS use the power inverter where there is adequate ventilation.
• NEVER block ventilation slots. NEVER install in an engine compartment or in any enclosed
area in the vehicle that does not allow air circulation.
• NEVER place materials that could be damaged by heat near the power inverter during use.
• ALWAYS make all DC connections before making AC connections.
• NEVER service an AC appliance without first disconnecting from the power inverter.
• NEVER connect the power inverter to live AC power circuits.
• Some chargers for small nickel-cadmium batteries can be damaged if connected to the
power inverter. Do not use the power inverter on the following items:
- Small battery-operated appliances such as flashlights, razors, and night lights. Charge
these items using a standard household outlet.
- Certain battery chargers for battery packs used in hand power tools. These chargers
will have a warning label indicating that dangerous voltages are present at the battery
terminals.
• Loose connections may cause wire overheating, melted insulation, and damage to the
power inverter.
• ALWAYS use the power cords that were included with the power inverter.
• NEVER use the power cords for any other purpose than with the power inverter.
• Connect the power inverter to batteries with a normal output of 12VDC only; Do not use
with 6V or 24V systems.
• NEVER use with positive ground electrical systems. Reverse polarity connections will result
in a blown fuse and may cause permanent damage to the inverter and void the product
warranty. (Most modern automobiles, RVs, and trucks are negative ground systems.)
• NEVER operate the power inverter in areas with high levels of dirt, dust, or debris.
• Follow ALL manufacturer instructions: power inverter instructions, battery manufacturer
instructions, and the manufacturer of any equipment intended for use with this power
inverter.
Safety Rules
5