Installing Gas Supply - Hobart Welding Products IronMan 210 Owner's Manual

3-9. Installing Gas Supply

.
DO NOT use Argon/Mixed gas
regulator/flowmeter with
shielding gas. See Parts List for
optional CO gas regulator/flow-
2
meter.
Tools Needed:
1-1/8, 5/8 in
OM-927 Page 14
CO
2
4
5
7
6
Rear Panel
1
2
3
Argon Gas Or
Mixed Gas
Obtain gas cylinder and chain to
running gear, wall, or other
stationary support so cylinder
cannot fall and break off valve.
1 Cap
2 Cylinder Valve
Remove cap, stand to side of
valve, and open valve slightly. Gas
flow blows dust and dirt from valve.
Close valve.
3 Cylinder
4 Regulator/Flowmeter
Install so face is vertical.
5 Regulator/Flowmeter Gas
Hose Connection
6 Welding Power Source Gas
Hose Connection
Connect customer supplied gas
hose between regulator/flowmeter
gas hose connection, and fitting on
rear of welding power source.
7 Flow Adjust
Typical flow rate is 20 cfh (cubic
feet per hour). Check wire
manufacturer's recommended
flow rate.
Ref. 220 747-A / 802 028-A / Ref. 802 286-E