Precor M9.21i Owner's Manual page 13

Diagram 8 Install the water
bottle cage.
Electronic console
Water bottle cage
Water bottle cage mounting location
Bolt (B) with washer (E)
Hex key ( I )
11. Return to the upper handrail clamp, check to see that the foam on the handrails touches the
12. Install the water bottle cage by placing one internal star washer (E) on each of the mounting
13. Plug the treadmill into a standard 120v household outlet. Make sure that no other appliances
14. Continue on to Checking the Alignment of the Running Belt to complete the installation of the
edge of the clamp, readjust the handrails if necessary, and tighten the bolts securely using the
3/16" hex key (H) provided.
bolts (B). Position the cage onto the mounting hole locations and insert the bolts. See
Diagram 8. Securely tighten the bolts using the 5/32" hex key ( I ). Place a water bottle inside
the cage as shown in the inset in Diagram 8.
use the same circuit as the treadmill. If you need to move the treadmill, ask for assistance
from one or more persons. Roll the treadmill on its front wheels to the new location by lifting
the rear end of the unit.
Important: Before you can roll the treadmill on its front wheels, set the incline at 3% or more.
Follow steps 1 through 4 in Checking the Alignment of the Running Belt, and then, adjust the
incline to a minimum of 3%. Turn OFF the treadmill and unplug it before moving it.
M9.21i or M9.21si treadmill.
page 13