Power Wheels JEEP WRANGLER 78490 Owner's Manual page 12

8
Steering Wheel
• Fit the steering wheel cap into the center of the steering
wheel with the screw holes aligned.
• Insert two #8 x 1" screws as shown.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
9
Wide Tab
Lens Guard
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
Assembly
Steering
Wheel
Cap
Wide Notch
Lens
12
10
28
• Face the front of the vehicle.
• Apply labels to the vehicle body grille as shown. Make
sure the areas where the labels will be applied are
clean and dry. For best adhesion, avoid applying the
labels more than once.
11
Slots
Tabs
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille