Assembly - Power Wheels JEEP WRANGLER 78490 Owner's Manual

F
1
Dash
2
1
Tab
1
• Position the dash on the vehicle body. Make sure the
holes in the dash tabs align with the holes in the vehicle
body and that the channel cover is captured by the dash.
• Insert two #10 x 1" screws through the holes towards the
rear of the dash (closest to the hood area) and into the
vehicle body .
1
• Insert two #10 x / " screws through the holes towards the
1
2
front of the dash (closest to the passenger compartment)
and into the vehicle body
• Tighten each screw with a Phillips screwdriver. Do not
over-tighten.
2
Knobs
Knob Plate
• Snap the knobs into the knob plate.
Note: Gently squeeze the tabs on the knobs together
before inserting the knobs into the knob plate.

Assembly

2
1
Channel
Cover
2
.
2
3
Dash
Key Assembly
• Bend the end of the microphone cord so that it forms a "T".
• Insert the end of the microphone cord through the square
opening in the dash pocket. Pull gently on the cord to make
sure it is secure in the dash.
• Hook the microphone onto the "U" slot on the dash pocket.
• Position the bottom edge of the knob plate in the opening
in the dash.
• Snap the top of the knob plate into the dash.
• Snap the key assembly into the dash.
4
9
11
17
3
• Before applying labels to the dash, wipe the dash with a
clean, dry cloth to make sure it is free of dirt and oils.
Make sure your hands are clean and dry.
• Apply labels as shown. For best results, avoid
repositioning a label once it has been applied.
10
Knob Plate
Pocket
Microphone
Cord
25
HI LO P
12
18
Dash View
T-End
24
TREB
PAUSE COMP RDM REV FWD
15