Sunbeam 4059 Instruction Manual page 5

1. When winding the cord, hold the plug with one hand, and press the winding
button with the other hand. (Failure to hold plug may cause plug to fly)
2. The cord reel is compact for multi-layer winding of the cord. In case cord is not fully rewound,
pull out the cord and steer cord evenly on the reel.
3. In case the cord is not pulled out easily, pull cord firmly.
4. Select the amount of cord desired before plugging in to an electrical outlet.
5. Do not allow children to use retractable cord feature as the cord may cause injury.
When turned on for the first time, your new iron may give off a slight odor for up to ten minutes.
l
This is-due to the initial heating of the materials used. It is safe, not detrimental to the
performance of the product, and will not recur.
Prior to first use, clean steam vents using the S
l
After cleaning vents, run iron over an all-cotton cloth to remove any residue.
When not ironing, always have steam dial turned to DRY. (See Diagram)
l
DRY IRONING
Plug the cord into a 120 volt AC outlet. On units with
l
automatic shut off: the auto off light will illuminate.
Turn the temperature dial to the desired setting (refer o Ironing
l
Guide for recommended settings). While iron is heating,
place iron on heel rest on a stable, protected surface.
Set the steam dial on DRY to prevent steam flow if water is in
l
the tank.
STEAM IRONING
Make sure the plug is removed from the wall socket before filling the iron with water.,
l
Turn the steam dial to DRY.
l
Place the iron on its heel and open the water reservoir cover. Pour water slowly into the
l
water reservoir. Fill up to the maximum water level. To prevent the risk of burns,
use caution when filling a hot iron with water. Burns can occur from touching
hot metal parts, hot water or steam. Push firmly to close the cover. N
be used due to the special design of this iron. However, in areas with very hard water,
distilled or demineralized water is recommended.
Turn the temperature dial to any of the temperatures within the steam band and allow the iron
l
to heat for approximately 2 minutes before ironing. While heating, place iron on heel rest on
a stable, protected surface.
'I'
Turn steam dial to C,3 for regular steam, or to C$& for extra steam or
l
for ultra steam. N : When using extra or ultra steam, it may be necessary to fill the tank
OTE
more often.
U
SING
TRACTABLE
B THE
EFORE
HOT OF
I C
N S T R U T I O N
C
ORD
SE
S @ feature.
TEAM
S FOR USE
: Tap water may
OTE