Pioneer Elite PRO-530HDI Operating Instructions Manual page 87

Mode switch
1
2
3
CABLE CONTROL BUTTONS
CABLE, SAT and DTV cannot be selected at the same time.
When the mode switch is set to CBL/SAT the cable converter
connected to the Monitor can be operated using the buttons
1 to 5.
Cable converters which are made by other makers and are
not preset can also be operated using the remote control unit
if buttons 1 to 5 have learnt the functions (see page 84).
1 Direct channel selection buttons
Press the button (or buttons) that corresponds to the
channel that you wish to watch.
2 CH (channel) +, – buttons
Press plus (+) or minus (–) to tune in a higher or lower
channel.
4
3
SOURCE POWER button
5
Turns the power of the cable converter on and off.
4 CH ENTER button *
Fix the selected channel with the direct channel selection
buttons.
5 CH RETURN (channel return) button *
Press to switch between the current channel and the
channel you were watching immediately before.
* Some manufacturers do not preset CH ENTER and CH
RETURN. Use these buttons to learn if necessary.
REMOTE CODE SET UP
87