Pioneer PRO-510HD Service Manual page 13

5
Horizontal Size Adjustment
-3
1st FAC
Start
INPUT 1:Monoscope
or
INPUT TV
General
broadcasting
• Reference
The H PHASE adjustment is required if the left or right part of the screen becomes black, as illustrated below, depending on the format
of the input signal (Ex. component 31.5 kHz, RGB 33K etc.).
Ex. Component 31K
Animation
Black
screen
• About H. PHASE
In principle, adjustment of the data for the H. PHASE is not required.
Check whether the H. PHASE data are the factory-preset values, as indicated below:
PRO-610HD
Key No.
PRO-510HD
3 : H PHA (15K)
CH+ : H PHA (31K)
CH- : H PHA (33K)
9 : H PHA (31K RGB)
0 : H PHA (33K RGB)
The screen moves to the right or the left if the above data are in variance. (See the above figures.)
Note :
H PHASE is set in factory shipment by the most suitable value. But, there is the case that screen is missed as an upper figure occurs
by the signal format of other apparatus to be connected to.
A screen can be improved as the following by the readjustment. However, attention is necessory because in convenience may occur
when connected to another apparatus.
PRO-610HD, PRO-510HD, SD-582HD5, SD-532HD5
Note :
Screen mode : FULL
1
ANT
Adjust the size so that the picture is completely
displayed on the screen.
Animation
CH
SD-582HD5
SD-532HD5
80 80 15K : CONPOSITE, S COMPONENT (480i)
31K : COMPONENT (480P)
36 40
33K : COMPONENT (1080i)
-14 -8
26 30
-26 -20
Green screen
H.SIZE
Animation
Move the part of animation leftward with CH+.
Note :
• After the V. SIZE adjustment,
enter the H. SIZE adjustment
by pressing "1" key.
• After the H. SIZE adjustment,
check that V. SIZE is 91 2%.
If not, readjust the V. SIZE.
91% 2%
VOL
205