Table of Contents
Advertisement
Symptom
The map continually reorients itself.
Tracking marks are not displayed.
The daylight display is used even
when the vehicle lights are on.
The system will not switch on or will
not operate.
The display is very dim.
There is no voice guidance or the vol-
ume is low.
The remote control fails to work.
When the screen is frozen...
Park your vehicle at a safe place, and cut the engine off. Turn the ignition key back to "Acc off". Then
start the engine again, and turn the power to the navigation unit back on. If this does not solve the
problem, press the RESET button on the navigation unit.
104
Cause
Setting of the Installation direction
lever is wrong.
Indication of the position of your
vehicle is misaligned after a U-turn or
reversing.
The traveling direction is always set
to north.
The "Tracking Display" is turned
off.
Daytime is selected on "Day/Night
Display".
The Orange/white lead is not con-
nected.
Installation or connection has been
carried out incorrectly.
The vehicle's light is turned ON, and
"Nighttime" is selected on "Day/
Night Display".
The vehicle cabin temperature is
extremely low.
The volume setting is low or the
speaker lead is disconnected.
The batteries are low.
The batteries have been inserted
incorrectly.
The remote control is pointing at the
floor or a seat.
The signal receptor on the display is
exposed to direct sunlight.
Settings of the dipswitch are wrong.
Setting of the operation mode switch
is wrong.
Action (See)
Check the installation position of the
navigation unit of your Navigation
System and the setting of the Instal-
➞
lation direction lever (
"Installation
Manual").
Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The Navigation Sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
Check the "Map Orientation" set-
➞ Page 51
tings (
) and change the
setting to "North Up".
Check the "Tracking Display" set-
➞ Page 50
tings (
) and make sure
"Always" or "This Trip" is selected.
Check the "Day/Night Display" set-
➞ Page 50
ting (
) and make sure
"Nighttime" is selected.
Check the connection.
Check with your dealer.
Read about the "Day/Night Dis-
➞ Page 50
play" setting (
desired, select "Daytime".
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
Check the volume setting on the dis-
play or turn the volume up according
➞
to "Hardware Volume" (
Page 50
) and/or turn up the volume
on the display.
Change the batteries.
Check that the batteries are properly
inserted according to the + and –
markings.
Ensure that the remote control has a
clear line of sight to the display unit.
Move the remote control closer to the
receiver on the display unit.
Specify it correctly according to the
➞ Page 94
equipment. (
)
Switch the operation mode switch to
"NAVI" to operate navigation.
When operating AV equipment,
switch the operation mode switch
correctly according to the equipment
➞ Page 54
to use. (
)
) and, if
Advertisement
Table of Contents
