Troy-Bilt 466 Operator's Manual page 8

Insert post of cable ties that are on lower handle
into the holes provided on the lower handle. The
holes may be on the inside or outside. Pull cable
ties tight and cut off the extra. See Figure 6.
Cable Tie
\\
\
POSton
Cable Tie
Figure 6
Attaching DriveAdjusterBlock
The drive adjuster block is attached to the drive cable.
• Remove bolt attached to the lower right handle.
• Align the drive adjuster block, curved side against
handle, with hole in handle.
• Secure drive adjuster block with bolt previously
removed.See Figure 7.
Adjuster
Block
Figure 7
Attaching StarterRope
The rope guide is already attached to the right side of
the lower handle of your mower. See Figure 8.
• With the spark plug wire disconnected and
grounded, hold the blade control handle against the
upper handle, and pull the starter rope up to the
rope guide. See Figure 8.
• Slip the rope through the rope guide as shown
below. Tighten the wing nut holding the rope guide
to the lower handle.
Slip rope into
rope g "u__._ing Nut
Figure 8
GrassCatcher A ssembly
If the grass catcher is not already assembled, follow the
steps below to assemble it. Otherwise go to the next
sub-section on Attaching Grass Catcher.
NOTE: Make certain the grass bag is turned right side
out before assembling (warning label will be on the
outside).
Partsfor GrassBag
1. Front Frame
2. Rear Frame
3. Bag
AssemblingGrassBag
• Join the rear frame and front frame assembly as
shown in Figure 9A.
• Place the bag over the frame (black plastic side is
the bottom of bag). Slip the openings in the side of
the plastic channels on the bag over the hooks on
the grass catcher frame.
• Secure bag to frame by working the plastic
channels on bag over frame as shown in Figure 9B.
All of the plastic channels except the center top of
the bag attach from the outside of bag. The center
top of the bag attaches from inside the bag.
[] []
Hook
_ Assembly
•-_ Rear
Frame
Figure 9
AttachingGrassCatcher
Bag
Plastic
Channels
If your mower is equipped with a rear baffle, and it
is in place on the mower, lift the rear discharge door
and remove it from the mower. See Figure 10.
Rear
Baffle
/
Figure 10