Extend Terminal Control - Pioneer DVD-V5000 Command Protocol Manual

9.

EXTEND TERMINAL CONTROL

To activate a function, create a switc
Ch apter 2 to verify pin (Pin 6 through Pin 13) and terminal (SW1 ~ SW8) assignm
There re t a hree S
1. To recall B arc
Th e f uncti on, STACK
of remote control buttons to recall and execute a stack.
2. To execute the function as a remote control command
The function acts the same as the buttons (ENTER, PLAY, STOP etc.) o
control excluding SCAN FWD/REV.
DV D- V500 0
re mot e con rol is release
to execute SCAN FWD/REV when button is released.
(In ca se o f e r
Bu t in cas of EX END e
op era tion.)
3. To execute as an advanced remote control button
Advanced remote control commands such as nu
as a s witc h c
Note : fo r a ddi
1 5260 DVD- 7400 nd Ja a Port 1
w ebsi te
W func ons in he EX ti t
ode /Co mm and Sta cks nd exec
GROUP 1 to STACK GROU 27, is
continues execute SCAN FWD/REV even
t d. But in case o
mote co ntro l "r elea sin
T T ERMI AL, re asing SCAN switch will terminate SC
ontro omm l c an d.
tional assist an ce, p ease r fer to
V a m
under Service & Support – Business Solutions Products.
h contact with an electrical ground (Pin 1). Check
TE ND T ER MINAL CONT OL.
a ute
P
f EX TEND TERMINAL CONTROL, it s
g SCAN button" will not discontinue the
N le
mbers from 10 to 20
l e P roduct Information Bulletin (PIB)
Co ntrol available on the
- 68
DVD-V5000 DVD Player
RS-232 Command Protocol
ents.
R
similar to a combination
, n a remote
when the button on the
tops
SCAN.
may be sent
Pioneer Ele tronics c
AN