Table of Contents
Advertisement
How toAttach O ptions tothePlasma M onitor
You can attach your optional mounts or stand to the plasma
monitor in one of the following two ways:
* While it is upright. (See DrawingA)
* As it is Laiddown with the screen lace down (See Drawing
B). Lay the protective sheet, which was wrapped around
the monitor when it was packaged, beneath the screen
surface so as not to scratch the screen face.
Drawing A]
• This device cannot be installed on its own.
Be sure to use a stand or original mounting
unit. (Wall mount unit, Stand, etc.)
* See the inside of a cover.
• For correct installation
and mounting it is
strongly
recommended
to use a trained,
authorized dealer.
Failure
to
follow
correct
mounting
procedures
could result in damage to the
equipment or injury to the installer.
Product warranty
does not cover damage
caused by improper installation.
I Drawing B I
* Use only Listed Cart or Stand, or mounting
kit or stand provided by manufacturer.
Ventilation
Requirements
for
enclosure
mounting
To allow heat to disperse, leave space between
surrounding objects as shown on the diagram
below when installing,
31 mm (1.22")
I
31 ram (1.22")
iiiiiiiiiiiiiiiiii_i_iiill
r
L
i
(2")
Advertisement
Table of Contents
