G
Battery Installation/Pretend Engine Assembly
1
Hood
• Lift the hood.
• Place the battery in the battery compartment. Make sure
that the battery connector extends toward the motor har-
ness connector.
2
Motor
Harness
Connector
• Squeeze the tabs on each side of the motor harness
connector.
• Plug the battery connector into the motor harness
connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over an try again. Do not force
the battery connector into the motor harness connector.
3
Battery
Connector
Battery
Motor
Harness
Connector
• Fit the pretend engine cover over the battery, motor
harness connector and battery connector.
• Insert two #8 x 18 x 1" fasteners through the holes in the
pretend engine and into the vehicle body.
• Tighten the fasteners with a Phillips screwdriver. Do not
over-tighten.
4
Battery
Connector
• Lower the hood.
• Lift the hood latches and fit the short tabs onto the
notches on the hood to fasten it.
16
Pretend
Engine
Cover
Hood
Hood
Latches