Connecting A Cable Converter Box And Vcr - Toshiba TheaterWide 27HL85 Owner's Manual

Connecting a VCR
This connection allows you to watch local channels and video
programs, play or record on the VCR while watching TV, and record
from one channel while watching another channel.
You will need:
• two coaxial cables
• one set of standard A/V cables
From Cable Box or Antenna
Stereo VCR
TV upper
back panel
Note:
If you have a mono VCR, connect L/Mono to
VCR Audio OUT using only one audio cable.
ff you have a VCR with S-video, use an
S-video cable instead of a standard video
cable.
The unauthorized recording, use,
distribution, or revision of television
programs,videotapes, DVDs, and other
materialsis prohibited under the
Copyright Laws of the United States and
other countries, and may subject you to
civil and criminal liability.
Connecting a cable converter box and VCR
This connection allows you to watch and record basic and premium
cable channels, as well as watch videotapes. Set the TV signal source
to VIDEO-1 (page 44). Tune the VCR to channel 3 or 4 (the same
channel as the converter box output switch), and use the cable
converter box to change channels.
• three coaxial cables
• one set of standard A/V cables
Stereo VCR
L
From cable
Cableconverterbox
TV upper
back panel
Note:
• When you use a converter box #viE/? y our
TV, the channel selectk)n feature does not
operate.
• When you use a converter box with your
TV, the remote control may not operate
some features, such as programming your
favorite channels, labeling channels, and
Iockff}g channels.
• ffyou have a mono VCR, connect L/Mono
to VCR Audio OUT using only one audio
cable.
ff you have a VCR with S-video, use an S-
video cable instead of a standard video
cable.
The unauthorized recording, use,
distribution, or revision of television
programs, videotapes, DVDs, and other
materials is prohibited under the
Copyright Laws of the United States and
other countries, and may subject you to
civil and criminal liability.
TV lower
back pane
10