Toshiba SD-V393SU Owner's Manual page 19

S-video output
An S-Video connection is superior to Video (Yellow) output. Use this method for DVD playback when the connected television has S-
Video input, and does not have component video inputs.
Component video outputs
[] PROGRESSIVE outputs
Some TVs or monitors are equipped with component video inputs that are capable of reproducing a progressively scanned video
signal. Connecting to these inputs allows you to view the highest quality pictures with less flicker.
[] INTERLACED outputs
Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the highest quality
DVD picture playback.
Notes:
• Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR)
• In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In such a
case, adjust the TV or monitor for optimum performance.
The S-video output and component video output transports the DVD-video signal exclusively and will deliver enhanced DVD
video picture performance.
_ Signal fl0w
0
o
&
o
÷
TOAuDIO(white)ANALOGouT _ e
_:_1 _ Qj
(red)
To wall outlet
............ If you connect the DVD/VCR to
ToS- ToPrdCR I ToPB!CB_ToY _ your TV with the DVD OUT jacks,
VIDEO VIDEO I VIDEO I VIDEO select the corresponding video
OUT bUT OUT OUT
L
input on your television to watch
Component DVD video discs.
video cable
(not suppliec Audio cable (not supplied)
To audio inputs of -'l /
the amplifier _
To Y video input
To PB/CBvideo input
To PR/CRvideo input
To S-video input
S-video cable (not supplied)
[] To switch the scan mode between the
interlace and progressive modes, see
page 59.
(white)
TV or monitor with Audio system
ColorStream _
component video inputs
Notes:
• Refer to the owner's manual of the connected equipment as well.
• When you connect the DVD/VCR to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• If you place the DVD/VCR near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD!
VCR away from the tuner and radio.
• The output sound of the DVD/VCR has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD/VCR's power cord. If you leave the amplifier power on, the
speakers may be damaged.
• When connecting to a TV using the Video or S-video jack, make sure that the Progressive indicator "{_" on the
display window is not lit. if it is lit, the Video and S-video outputs do not feed the correct signals and you cannot see
any picture. To turn off the Progressive indicator, select PROGRESSIVE scan Off _.
19
÷
2H20101A (E)pt8-25 19 _ 2/10/05, 7:32 PM