Troubleshooting Guide - Heath Zenith DUAL BRITE SL-5597 User Manual

SYMPTOM POSSIBLE CAUSE
Lights will 1. Light switch is turned off.
not come 2. Light is loose or burned out.
on. 3. Fuse is blown or circuit breaker is turned
off.
4. Daylight turnoff is in effect (recheck
after dark) .
5. Incorrect circuit wiring, if this is a new
installation.
6. Re-aim the sensor to cover desired area.
Lights come 1. Light Control may be installed in a
on in relatively dark location.
daylight. 2. Light Control is in Test. (Set control
switch to an ON-TIME position) .
Lights come 1. Light Control may be sensing small
on for no animals or automobile traffic (re-aim
apparent sensor) .
reason. 2. Range is set too high. (Reduce Range
setting) .
3. Dual Brite™ Timer is on.
Lights turn 1. Sensor is in a relatively dark location.
off too late (Relocate sensor, or use 3 hr or 6 hr
in Dusk-to- setting) .
Dawn
setting.
See your Canadian Tire retailer for warranty information.

TROUBLESHOOTING GUIDE

If you experience a problem, follow this guide.
SYMPTOM POSSIBLE CAUSE
Lights stay 1. A lamp is positioned too close to the
on continu- sensor or pointed at nearby objects
ously. that cause heat to trigger the sensor.
(Reposition the lamp away from the
sensor or nearby objects) .
2. Light Control is pointed toward a heat
source like an air vent, dryer vent, or
brightly-painted heat-reflective surface.
(Reposition sensor. Reduce Range) .
3. Light Control is in Manual Mode.
(Switch to Auto) .
Lights flash 1. Heat or light from the lamps may be
on and off. turning the Light Control on and off.
(Reposition the lamps away from the
sensor) .
2. Heat being reflected from other ob-
jects may be affecting the sensor.
(Reposition sensor) .
3. Light Control is in the Test mode and
warming up. (Flashing is normal un-
der these conditions. Turn Boost off) .
Lights flash 1. Sensor is detecting its own lights.
(Reposition lamps to keep area be-
once, then
stay off in low the sensor relatively dark).
Manual Mode.
4 598-1038-03