Meridian 861 User Manual page 34

CUSTOMISING THE 861 PREFACE
REFERENCE DIGITAL
SURROUND CONTROLLER
Parameter
Treble
Bass
Phase
Axis*
Balance
HS Out?*
Centre
Depth
Rear
Sides
R Delay
S Delay
LipSync
Standard parameters
All DSP presets (except Mono, Stereo, and Direct) provide these parameters:
Options
-10dB to +10dB
-5dB to +5dB
+ or -
-2 to +3
<10 to 10>
Y or N
-3.0dB to +3.0dB
-2.5ms to +5ms
-30dB to +10dB
-30dB to +10dB
0ms to 30ms†
0ms to 30ms†
0ms to 30ms
* Only available with compatible hardware; contact your Meridian dealer.
† Certain presets may have a reduced range.
Individual DSP presets provide additional parameters, to allow you to
adjust specifi c features provided by that preset. For full details refer to DSP
presets, page 37.
Note: Parameters not relevant to your confi guration, such as Sides in a
fi ve-speaker system, are omitted from the sequence of menus.
To change a DSP parameter
• Make sure the menus are unlocked; see To unlock the menus, page 24.
• Press > or < (remote or under the front panel) until the display shows
the name of the parameter you want to change.
For example:
• Press A or V (remote or under the front panel) to change the value of
the parameter.
Default What it changes
+0.0dB The slope of the frequency response.
+0.0dB The bass response.
+ The absolute phase.
-1 The vertical balance.
<0> The L-R balance.
Y Select Y for high-rate audio, upsampled
if necessary. Select N for standard-rate
audio, downsampled if necessary.
+0.0dB The level of the centre.
+0.0 The relative delay of the centre.
+0dB The relative level of the rears.
+0dB The relative level of the sides.
0.0 The relative delay of the rears.
0.0 The relative delay of the sides.
0.0 The sync. delay.
CD
26
Depth +0.0