Advertisement
Seat Back Tube
5
• Position the seat back tube so that the square openings
are upright.
• Fit the seat back tube onto the ends of the base wire.
• Push the seat back tube to be sure it is completely on the
base wires.
6
• Insert a #8 x 1,9 cm (
/
") screw into the inside hole of each
3
4
handle and tighten.
• Pull up on the seat back tube to be sure it is secured to the
left and right base wires.
Square Openings
Assembly
Bottom Pocket
7
• Fit the pad seat back pocket over the seat back tube.
• Pull and fit the pad seat bottom pocket around the soothing
unit and footrest.
Handles
8
• Fit the handles through the side openings in the pad.
5
Seat Back Pocket
Advertisement
