Jonsered BC2126 Operator's Manual page 16

STARTING AND STOPPING
NOTE: if engine dies, return blue engine
choke lever to the closed position and
repeat starting steps.
CAUTION! Do not pull the starter cord al_
the way out and do not let go of the starter
handle when the cord is fully extended.
This can damage the machine.
Warm engine
With a warm engine, squeeze and hotd the
throttle trigger. Pull starter rope sharpty
while squeezing throttle trigger until engine
runs.
CAUTION!
Do not put any part of your body in marked
area, Contact can result in burns to the
skin, or electrical shock if the spark plug
cap has been damaged, Always use
gloves, Do not use a machine with dam-
aged spark plug cap.
For throttle handles with a start
throttle lock:
Set the throttle to the start position by first
pressing the throttle lock and the throttle
trigger, then pressing the start throttle
button (A). Then release the throttle lock
and the throttle trigger, followed by the start
throttle button, The throttle function is now
activated, To return the engine to idle,
)tess the throttle lock and throttle trigger
again.
Stopping
Stop the engine by pushing and holding
the stop switch in the STOP position until
the engine stops.
CAUTION! The stop switch automatically
returns to the start position. In order to pre-
vent unintentional starting, the spark plug
cap must be removed from the spark plug
when assembling, checking and/or per-
forming maintenance.
WARNING:
When the engine is
started with the choke in the closed
position the cutting attachment will
start to rotate immediately.
16