Poulan Pro BP400 Instruction Manual page 3

may void your warranty and cause damage
to your unit.
• Empty fuel tank before storing the unit. Use
up fuel left incarburetor by starting engine and
letting it run until it stops.
• Do not use any accessory or attachment
other than those recommended by manufac-
turer for use with your unit.
• Do not store the unit or fuel in a closed area
where fuel vapors can reach sparks or an
open flame from hot water heaters, electric
motors or switches, furnaces, etc.
• Store in a dry area out of reach of children.
SPECIAL NOTICE: Your blower is
equipped with a temperature limiting muffler
and spark arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
lawthat many internal combustion engines be
equipped with a spark arrestor screen. If you
operate a blower in a state or locale where
such regulations exist, you are legally re-
sponsible for maintaining the operating condi-
tion of these parts. Failure to do so is a viola-
tion of the law.
SPECIAL NOTICE: Exposure to vibra-
tions through prolonged use of gasoline pow-
ered hand tools could cause blood vessel or
nerve damage in the fingers, hands, and
joints of people prone to circulation disorders
or abnormal swelling. Prolonged use in cold
weather has been linked to blood vessel dam-
age in otherwise healthy people. If symptoms
occur such as numbness, pain, loss of
strength, change in skin color or texture, or
loss of feeling in the fingers, hands, or joints,
discontinue the use of this tool and seek
medical attention. An antivibration system
does not guarantee the avoidance of these
problems. Users who operate power tools on
a continual and regular basis must monitor
closely their physical condition and the condi-
tion of this tool.
d_I_WARNING:
If you receive your unit
assembled, check each step to insure your
unit is properly assembled and all fasteners
are secure. Follow all safety information in
the manual and on the unit.
• Locate and identify all components.
• Slip one hose clamp onto each end of the
flexible tube.
• Install the flexible tube onto the output tube
on the engine.
• Connect the base tube to the flexible tube
and securely tighten both hose clamp
screws.
• Assemble the middle tube and nozzle, then
connect them to the base tube.
CARTON CONTENTS
t. Engine Assembly
2. Hose Clamp with Screw
3. Flexible Tube
4. Base Tube
5. Middle Tube
6. Nozzle
7. Assembly Tool
,Hose Clamps
i
Base Tube
Flexible Tube _1
Middle Tube Nozzle
-3-