Poulan Pro BVM200VS Instruction Manual

Poulan Pro BVM200VS Instruction Manual

Hide thumbs Also See for BVM200VS:

Advertisement

Please do not return unit to retailer.
Por favor, no devuelva el aparato al lugar de compra.
Veuillez ne pas retourner l'outil au détaillant.
IMPORTANT MANUAL - - Do not throw away
MANUAL IMPORTANTE - - No lo descarte
MANUEL IMPORTANT - - À Conserver
WARNING:
Read and follow all Safety Rules and Operating Instructions before
using this product. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual de instrucciones y siga todas las advertencias e
instrucciones de seguridad. El no hacerlo puede resultar en lesiones
graves.
AVERTISSEMENT:
Veuillez lire le manuel d'instructions et bien respecter tous les
avertissements et toutes les instructions de sécurité. Tout défaut
de le faire pourrait entraîner des blessures graves.
Poulan PRO
1030 Stevens Creek Road
Augusta, GA 30907
1- -800- -554- -6723
www.poulan- -pro.com
Instruction Manual
Manual de Instrucciones
Manuel d'Instructions
850 Matheson Blvd. West
Mississauga, Ontario L5V 0B4
545146927 Rev. 9 3/11/09 BRW
R
BVM200VS
Poulan PRO

Advertisement

Table of Contents
loading

Summary of Contents for Poulan Pro BVM200VS

  • Page 1 1- -800- -554- -6723 www.poulan- -pro.com Instruction Manual Manual de Instrucciones Manuel d’Instructions BVM200VS IMPORTANT MANUAL - - Do not throw away MANUAL IMPORTANTE - - No lo descarte MANUEL IMPORTANT - - À Conserver WARNING: Read and follow all Safety Rules and Operating Instructions before using this product.
  • Page 2 IDENTIFICATION OF SAFETY SYMBOLS WARNING: This unit can be dangerous! Careless or improper use can cause serious injury. Read your operator’s manual carefully until you completely understand and can follow all warnings and safety rules before operating the unit. Failure to do so can result in serious injury. Save operator’s manual. The blower can throw objects vio- lently.
  • Page 3 IDENTIFICATION OF SAFETY SYMBOLS When using the vacuum attachment, the unit is designed to pick up dry material such as leaves, grass, small twigs, and bits of paper. Do not vacuum stones, gravel, metal, broken glass, etc., to avoid severe dam- age to the impeller.
  • Page 4 Use only recommended Poulan PRO re- rotating blades. placement parts; use of any other parts Inspect unit before each use for worn, may void your warranty and cause damage loose, missing, or damaged parts.
  • Page 5 ASSEMBLY 6. To remove the tubes, turn the knob coun- WARNING: terclockwise to loosen the tubes; remove Stop engine and be sure the tubes. the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- HIGH- -SPEED NOZZLE ASSEMBLY tempting to insert or remove the vacuum or When greater air speed is desired, use the blower tubes.
  • Page 6 blower tubes. The rotating blades can cause 6. Align slanted end of lower vacuum tube as serious injury. shown. Firmly push lower vacuum tube 1. Insert the tip of a screwdriver into the latch into upper vacuum tube. area of the vacuum inlet. Blower Latch Area Outlet...
  • Page 7 OPERATION KNOW YOUR BLOWER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Upper Vacuum Tube Elbow Tube Lower Vacuum Tube Vacuum Bag...
  • Page 8 WARNING: When starting engine, ratio of 40:1. Poulan PRO brand synthetic oil is recommended. Mix gasoline and oil at a ratio of hold the unit as illustrated. Do not set unit on any surface except a clean, hard area when starting 40:1.
  • Page 9 INSPECT AND CLEAN UNIT AND service dealer performs work on the DECALS product, Poulan PRO may not pay for S After each use, inspect complete unit for repairs under warranty. It is your re- loose or damaged parts. Clean the unit and...
  • Page 10 CLEAN AIR FILTER CHECK MUFFLER MOUNTING A dirty air filter decreases engine perform- SCREWS ance and increases fuel consumption and Once each year, ensure muffler mounting harmful emissions. Always clean or replace screws are tightened securely to prevent air filter after every 5 hours of operation or damage.
  • Page 11 CARBURETOR IDLE SPEED Idle Speed Screw ADJUSTMENT The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions: S Engine will not idle when the throttle is re- leased. To adjust idle speed: Allow engine to idle.
  • Page 12 TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not 1. See “Starting a Flooded Engine” 1. Engine flooded. in Operation section.
  • Page 13 Magnuson- -Moss Act manual. This warranty does not cover trans- of 1975. portation costs. The policy of Poulan PRO is to continuously In the event you have a claim under this warran- improve its products. Therefore, Poulan...
  • Page 14 Poulan PRO at lowing a warranty claim. Poulan PRO is not li- 1- -800- -554- -6723, or send e-mail correspon- able to cover failures of warranted parts dence emission.warranty@HCOP- -...

Table of Contents