Page 1
1- -800- -554- -6723 www.poulan- -pro.com Instruction Manual Manual de Instrucciones Manuel d’Instructions BVM200 LE IMPORTANT MANUAL - - Do not throw away MANUAL IMPORTANTE - - No lo descarte MANUEL IMPORTANT - - À Conserver WARNING: Read and follow all Safety Rules and Operating Instructions before using this product.
IDENTIFICATION OF SAFETY SYMBOLS WARNING: This unit can be dangerous! Careless or improper use can cause serious injury. Read your operator’s manual carefully until you completely understand and can follow all warnings and safety rules before operating the unit. Failure to do so can result in serious injury. Save operator’s manual. WARNING: The muffler is very hot during and after use.
IDENTIFICATION OF SAFETY SYMBOLS WARNING: Stop the engine before opening the vacuum inlet door. The engine must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. Gently tilt the handle of the screwdriver toward the back of the unit to release the latch while pulling up on the vacuum inlet cover with your other hand.
OPERATE YOUR UNIT SAFELY maintenance except for carburetor adjust- ments. WARNING: Use only recommended Poulan PRO re- Stop the engine before placement parts; use of any other parts opening the vacuum inlet door. The engine must may void your warranty and cause damage be stopped and the impeller blades no longer to your unit.
ASSEMBLY WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury. Always disconnect the spark plug before performing maintenance or ac- cessing movable parts.
5. Place the hooks of the upper vacuum tube 3. Remove the vacuum bag. on the retaining posts of the unit. 4. Close the vacuum inlet cover and make sure 6. Pivot the tube until it is secured to the blower it is latched closed.
OPERATION KNOW YOUR BLOWER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Upper Vacuum Tube Lower Vacuum Tube...
Page 8
2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan PRO brand synthetic oil is recommended. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3.2 ounces (95 ml)
INSPECT AND CLEAN UNIT AND service dealer performs work on the DECALS product, Poulan PRO may not pay for S After each use, inspect complete unit for repairs under warranty. It is your re- loose or damaged parts. Clean the unit and...
CLEAN AIR FILTER REPLACE FUEL FILTER To replace fuel filter, drain unit by running it dry of fuel, then remove fuel cap/retainer assem- bly from tank. Pull filter from tank and remove it from the fuel line. Install new fuel filter on fuel line;...
Page 11
FUEL SYSTEM ENGINE Under FUELING ENGINE in the OPERA- S Remove spark plug and pour 1 teaspoon of TION section of this manual, see message la- 40:1, 2-cycle engine oil (air cooled) through beled IMPORTANT regarding the use of ga- the spark plug opening.
You are responsible for present- must warrant the emission control system on ing your small off- -road engine to a Poulan PRO your small off- -road engine for the periods of authorized repair center as soon as a problem time listed below provided there has been no exists.
Page 13
Poulan PRO at 1- -800- -554- -6723. up to the first scheduled replacement point for WHERE TO GET WARRANTY SERVICE: that part.