Table of Contents
Advertisement
ASSEMBLY
3.
HOW TO INSTALL
THE SEAT
Use the fasteners shown below to installthe seat. The fasteners are
shown at full size.
Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
1.
2.
©
(A)
(B)
94160
17x47Z
Carefully remove the plastic bag from the seat.
Align the holes in the seat hinge to the holes in the seat
(Figure 1). Fasten the seat to the seat hinge with the fasteners
as shown.
, Seat
Seat Hinge
Seat
Adjusting Hole
HOW TO ASSEMBLE THE STEERING WHEEL
Fasteners are not required to assemble the steedng wheel. Attach
the steering wheel as follows:
1.
Make sure the front wheels point forward.
2.
Look at the hub ofthe steering wheel. Make sure the locking
clip is in place inside the hub.
3.
Slide the cover over the steering post (Figure 2).
4.
Slide the steering wheel onto the steering post. Push on the
steering wheel. The steering wheel will lock onto the steering
post. Pull on the steering wheel. Make sure the steering wheel
is locked in place.
5.
Some models have an optional decal in the parts bag. Attach
the decal to the center of the steering wheel as shown.
Steering Wheel
Steering Post
Hub
Cover
HOW TO ASSEMBLE
THE GAUGE WHEELS
Use the fasteners shown below to install the gauge wheels. The
fasteners are shown at full size.
1.
Attach the gauge wheels to the axle bolts with the fasteners.
NOTE: The axle bolt is mounted in the LOW position. To change
the position to a higher cutting position, see "How To Adjust
The Gauge Wheels" in the Maintenance
section.
F- 98895
lO
Gauge Wheel
Figure 3
Advertisement
Table of Contents
