Table of Contents
Advertisement
MAINTENANCE
MAINTENANCECHART
PROCEDURE
RRST
EVERY
EVERY
EVERY
EACH
2
25
50
100
USE
HOURS
HOURS
HOURS
HOURS
BEFORE
STORAGE
M
O
W
E
R
Blade Rotation Control, Check
Motion Drive Belt, Check
Battery, Check and Charge
¢
¢
_i_iiii_i_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
¢
¢
Lubrication
!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiii
GENERAL RECOMMENDATIONS
1.
The owner's responsibility is to maintain this product. This will
extend the life of the product and is also necessary to maintain
warranty coverage.
2.
Check the spark plug, drive brake, lubricate the unit, and clean
the air filter once a year.
3.
Check the fasteners. Make sure all fasteners are tight.
4.
Followthe Maintenance section to keepthe unit in good operat-
ing condition.
A
WARNING: Before you make an inspection, adjust-
ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the wire from the spark plug to
prevent the engine from starting by accident.
NOTE: Torque Is measured in foot pounds (metric Nm). This
measurement
describes how tight a nut or boR must be. The
torque is measured with a torque wrench.
HOW TO CHECK THE MUFFLER
Check the muffler every 50 hours. Make sure the muffler is correctly
mounted and is not loose. If the muffler isworn orburnt, replace with
a new muffler. Awom muffler is a fire hazard and can also damage
the engine.
If you mount a spark arrester to the muffler, also check the spark
arrester when you check the muffler. If the spark arrester is worn or
damaged, replace it with a new spark arrester. See your nearest
authorized service center for a spark arrester.
F- 98895
20
Advertisement
Table of Contents
