How To Install The Seat; How To Assemble The Steering Wheel - Murray SELECT 425001x8A Manual

HOW TO INSTALL THE SEAT

1. Carefully remove the plastic bag from the seat.
Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
1001054
NOTE: Fasteners may be attached to seat for shipping
purposes, if so remove fasteners before proceeding.
2. Align the holes in the seat hinge to the holes in the seat
(Figure 1). Fasten the seat to the seat hinge with the fasteners
as shown.

HOW TO ASSEMBLE THE STEERING WHEEL

Attach the steering wheel as follows:
(A)
25x3
1. Make sure the front wheels point forward.
2. Slide the cover over the steering post (Figure 2).
3. Slide the steering wheel onto the steering post.
4. Use the fasteners shown above to secure the steering wheel.
The fasteners are shown at full size. Tighten the screw. DO
NOT over tighten.
5. Remove adhesive backing from hub cover (found in parts bag)
and place hub cover over hub.
F–040715L
ASSEMBLY
3.
(B)
17x47
(C)
17x146
11
Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
Hub
Cover
Cover
Steering Post
Seat
Seat Hinge
Seat
Adjusting Hole
B
A
Figure 1
A
C
Steering Wheel
Figure 2