Connect Wires - Philips CED1900BT User Manual

Connect wires

Note
•
Make sure that all loose leads are insulated with
electrical tape.
•
Consult a professional to connect wires as instructed
below.
•
Before connection, check the car's wiring carefully.
1
Connect the ISO male connectors.
ISO male connectors
1 Green strip, black-
edged green strip
2 White strip, black-
edged white strip
3 Gray strip, black-
edged gray strip
4 Purple strip, black-
edged purple strip
e Red strip
f Blue strip
g Blue strip, white strip Amplifier relay
h Black strip
i Yellow strip
8 EN
Connect to
Rear left speaker
Front left speaker
Front right speaker
Rear right speaker
Ignition key +12V
DC when ON/ACC
Motor/electric
antenna relay
control lead
control lead
Ground
The +12V car
battery which is
energized at all times
2
Connect other wires if necessary.
Caution
•
To avoid an accident, the driver must not watch video
while driving. By design, this system disallows watching
video during drive. Park your car in a safe place and
engage the parking brake before watching video.
Note
•
When the parking brake of your vehicle is not engaged,
the video blocking system is activated. It blocks the
display of front video source only.
•
If the system is not properly connected with the
parking brake control module of your vehicle, video
signals will be blocked by the system, with the below
message displayed on the TFT.