Fisher & Paykel DOUBLE DISHDRAWER DD603I Accessory Installation Manual page 2

BEFORE YOU START
IMPORTANT
INTEGRATED PANEL THICKNESS
Upper and Lower Panel minimum thickness is
11
thicknesses above / " (18mm) can be accommodated but product depth
16
will increase accordingly.
INTEGRATED PANEL MATERIAL
Drawer Front material must be suitable for damp conditions
o o
(122 F/50 C @ 80% RH) and adequately sealed to withstand moisture.
Additional protection can be provided by using a "Moisture Resistant
Board". Taping edges alone may not provide adequate sealing. For
painted panels, radius all rear edges to improve sealing.
TOE KICK PREPARATION
TOE KICK OPTIONS
A) The Black Prefinished Toe Kick Panel is supplied. Refer to Installation
Instructions for preparation.
B) The Black Prefinished Toe Kick Panel can also have a front panel of
your choice attached to it using screws or an adhesive.
C) A Toe Kick panel of any material with thickness from
(9-19mm) can be screwed to a plastic Toe Kick Mounting Bracket
(supplied).
TOE KICK PANEL INSTALLATION DEPTH
When using a rectangular Toe Kick, the maximum depth, excluding the
5
Toe Kick Panel is 2 / " (67mm).
8
To move the Toe Kick deeper the Toe Kick Panel must have the profile
shown in the diagram below cut out of it. The maximum Toe Kick depth
with the cut out excluding the Toe Kick Panel is 5" (127mm).
PARTS SUPPLIED
Integrated Rectangular Badge (2)
(Satin Chrome supplied)
p.n 526975
Other Badges Available
Rectangular:
Bright Chrome Kit p.n 527276
Brass Kit p.n 527277
Eliptical:
Black Kit p.n 526683
Satin Chrome Kit p.n 526684
Bright Chrome Kit p.n 527156
Brass Kit p.n 526685
2
5
/ " (16mm). Panel
8
3 3
/ " - / "
8 4
Mounting Bracket (2)
(Upper and Lower)
p.n 526440 & 526441
Door Front Seal (2)
p.n 526466
Toe Kick Mounting Bracket (1)
p.n 526682
IMPORTANT
WARNING!
BE SURE THE PRODUCT IS NOT PLUGGED IN.
Important!
The installation of the Panels requires an electrical
connection and must be performed by a suitably
qualified person.
WIDTH OF TOE KICK PANEL
Refer to "Width of All Panels" on page 1.
HEIGHT OF TOE KICK PANEL
Refer to the diagram on page 1. Measure
adjacent cabinet door fronts to the floor and write it in the first box below,
then complete the equation.
For example:
1 15
34 / " 28
0"
(870mm)
4
[Door extension]
[Height of adjacent
cabinetry]
INTEGRATED PARTS KIT part no. 526674
Panel Panel
Preparation Mounting
Booklet (1) Screws (12)
TOOLS NEEDED
Safety Glasses, Tape Measure, Pencil, Needle-Nose Pliers, Drill & Phillips
ø
Bit or Phillips Screwdriver, 1" (25.4mm) Boring Bit or
Hole Saw, Small Hand or Jig Saw.
the height from the top of the
15
27
/ " / "
4
(735mm) (12mm)
16 32
15 15
28 / " / "
16 32
(735mm) (12mm)
R
[ [MIN
clearance]
dimension]
Toe Kick
Mounting
Screws (5)
ø
1" (25.4mm)
R
/ "
(123mm)
32
[height of Toe
Kick Panel,
3
MIN 2 / "
4
(70.5mm)]