Rear Bagging - MTD PR600N21RH Operator's Manual

MULCHER PLUG TYPE "A"
To convert to mulching operation, mulcher
plug must be installed into discharge open-
ing of mower.
o Open discharge guard.
• Insert tab of mulch plug into housing
opening.
• Align hooks of mulch plug over hinge
rod of discharge guard. Push mulch plug
down until mulch plug is seated in hous-
ing opening.
_CAUTION: Do not run your lawn mower
without discharge guard, approved grass
catcher or mulcher plug in place.
MOWER IS
NOW READY
FOR MULCHING
OPERATION
Hinge rod
Discharge
Housing
opening
Hooks
Mulcher plug
Tab
MULCHER PLUG TYPE "B"
To convert to bagging or discharging:
• Lift discharge guard and remove
mulcher plug.
• Mower can now be used for side dis-
charging or optional grass catcher can
be attached.
° "Tbreturn to mulching operation, simply
reinstall mulcher plug as shown, making
sure tab is seated properly_
_,CAUTION: Do not run your lawn mower
without discharge guard, approved grass
catcher or mulcher plug in place.
"COMBI-CUT" MOWERS
Your lawn mower was shipped ready to be
used as a mulcher_ To convert to bagging
or discharging:
REAR BAGGING
• Open rear door and remove mulcher
plate. Store mulcher plate in a safe
place.
• You can now install grass catcher.
o To convert to mulching or discharging
operation, install mulcher plug into rear
discharge opening of mower, making
sure all tabs are seated properly.
Lift
dischal
guard
Install
mulcher
Mulcher
plate tabs
SIDE DISCHARGING
° Mulcher plate must be installed into rear
discharge opening of mower (see above
instructions).
o Open mulcher door and install discharge
deflector under door as shown.
• Mower Is now ready for discharging
operation.
• To convert to mulching or bagging
operation, discharge deflector must be
removed and mulcher door must be
close&
Tab
10