Advertisement
irst let's connect your Antenna
or Cable TV signal to your TV.
Tkds will be easy since there is only
one 75_ antenna plug on the back
of your TV - arid that's where the
ar_lenna goes.
r-a-g-ffc
IF your anterina (or CABLE TV
signal) has a round cable (75 ohm)
with a metal prong (F-connector)
on the end, then you're ready to
connect it to the TV.
IF your antenna has flat twin-lead
wire (300ohm), you first need to
attach the antenna wires to the
screws on a 300 to 75 ohm adapter.
<
,PJ' Push the round end of the
adapter (or cable) onto the
ANTENNA plug on the rear of the
TV. If the round end of the cable
connector is threaded, screw it
down tight.
Try it out. Press POWER
to
turn the TV ON. Press the
CHANNEL UP button. You
should see local channels flash by.
Certain channel numbers have been
added to the TV's memory at the
factory. To set the TV to select
only the channel numbers in your
area, see page 11.
,__
Remember. If the TV is
I_ connected to a Cable TV
(CATV) signal, be sure to set the
TV for that type signal (see page
1o.)
To order any optional
accessory
contact
your dealer or call the toll-free
accessory
ordering
number
(1-800-292-6066):
UHF/VHF Combiner ........... SBV 1133A01
75-300 Ohm Adapter ........... SBVI 113A01
500-75 Ohm Adapter .......... 483521827003
Outdoor VHF/UHF
Antenna
Twin
l..ead
Wire
(
I!
Back of TV
Outdoor VHF/UHF Antenna
Cable TV Signal
Round Cable
75_
Advertisement
