Advertisement
our TV remote can be set to
work your VCR by what is
called
the SEARCH
method.
If the "REMOTE
CODE"
number
method
shown
in the previous
section did not set your remote to
work your VCR, then follow
the
easy steps listed below.
Please
read through
steps 1-4
before
beginning.
EeEG--g ra]
@>
Press the POWER
button
on
the VCR to turn VCR ON.
_>
Stand al least six feet away
from the front of the VCR.
Point
the remote
toward the
VCR.
HOLD
DOWN
the A/CH
and
VCR
System
buttons
at the same
time. KEEP HOLDING
BUTTONS
DOWN.
_>
Watch
the Channel
Indicator
on the VCR.
Channel
Numbers
will SCAN UP
when the VCR has been
identified.
"Ihis may take up to
two minutes.
i> Release
the A/CH
and VCR
System
buttons
as soon as
channel
numbers
start to scan up.
The VCR code has been identified
and the remote
is ready to operate
the VCR.
_[_31_ -'_
Remember.
A minute or
two can seem very long, but
the code should be located within
two minu_es.
Don't let the: VCR scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search
cycle will have to be repeated.
If no channel change happens
within two minutes, repeat steps
I-4. Should a channel change still
not occur, the remote will not
work with the desired VCR.
VCR
09
Don't let the VCR scan up
more than five channels
(in Search mode).
3O
1
Six Fee_t
(minimum)
Advertisement
