Advertisement
th the use of an optional Dolby
rround Prologic Amplifier you
can receive the added sound
dimension found only in Dolby
Surround programs. Dolby Surround
combines wide left-to-right stereo
separation with solid center channel
imaging, complemented by a front-to-
back soundfield effect. The result for
you the listener is to create a movie
theater or concert hall "you are there"
sound sensation.
_T_
Connect the FIXED Audio
I
utput jacks on the TV to the AUX
INPUT jacks on a Dolby Prologic
Audio Amplifier system.
<_-_
Connect the CENTER
v
CHANNEL Input jack on the TV to
the CENTER PRE-AMP jack on the
Dolby Prologic Amplifier.
_
Connect the rear set of Surround
Sound speakers to the (+,-)
connections on the Dolby Surround
Amplifier.
Place the Audio System's Front and
Rear Surround speakers as shown in
the picture on this page.
(=4_
Turn the TV ON. Set TV Volume
to
v
normal listening level. Place the TV's
TV SPEAKERS (Sound Menu 2 of 3)
control to "CENTER CHANNEL
INPUT".
Turn the Dolby Prologic Amplifier
ON. Place its SURROUND MODE
control to the l)_olby Prologic
mode.
_.J_j,_ The full effect of DOLBY
SURROUND
programs (either
broadcast, VCR, or VDP) can now be
heard through the TV and Amplifier
system speakers.
Remember. R(ight)/L(eft)
channel stereo sound and rear
Surround sound will be heard from the
external (or Dolby Prologic Amplifier
system) speakers. The TV's front
cabinet speakers are used for true
Center Channel sound necessary to
complete the Dolby Prologic Surround
arrangement.
You will need the following to set-up and use the designed
SURROUND SOUND system shown below:
• One set of rear Surround Sound speakers
[• One Dolby Prologic Audio Amplifier (with Center Pre-Amp
I
Output and twin speakers)
[ • One DOLBY SURROUND
encoded source (either playback -
VCR, VDP, etc.- or broadcast).
AUDIO
jack's volume, bass,aed tre_e
levels can be adjusted withthe
TV's VOl-_.v buttonsor us_g
the on-screen
Menu consols.
Audio
Left Front
Right Front
Speaker
Rear Surround Speakers
J
FLL REAR
SURROUND
SPEAKERS
R SPEAKER
OUTPUT
iF+o+
_
R, L AUDIO INPUT
Audio
CENTER
CHANNEL
PRE.AMP
OUT
Amplifier
LEFT SPEAKER
CENTER
CHANNEL
Use the noi_ .sequencer (or _und test signal) on
the Dolby Prologic Amplifier. Adjust the Center
Channel volume level (using the Dolby Prologic
Amp's Center Channel Volume control) to equal
the left/right and surround speaker volume levels.
If Center Channel volume is still too low after
using the Dolby Prologic Amplifier, use the TV's
Volume control buttons to m_'t d esired Center
Channel level.
Make sure the TV's BALANCE control is set to
the middle position or the Center channel sound
image will not be centered.
Use the Dolby Prologic Amplifier's
Volume
buttons to adjust the surround system ,soundlevel. :
I
I'
REAR SURROUND
SOUND SPEAKERS
m
RIGHT SPEAKER
I
26
Advertisement
