Philips 55PW9383 Directions For Use Manual page 8

Connecting Accessory Devices toYourTV
Tjhe TV's audio/video (A F) input jacks provide
r directpicture and sound connections
between the TV amt accessory devices such as'
VCRs, DVD players, and others that have AV out-
put jacks.
This" example, which uses the INPUT-AV l jacks,
shows you one way to connect a VCR to ),our TE
Re[Or to the directions-jbr-use manual /br your
VCR jbr f!_rther in/brmation on connections.
To make the connections shown in this example,
you will need:
• one coaxial cable (75_)
• one cablejbr a video connection (standard
RCA connectoO
• two cables/br audio connections (standard
RCA connectors) (only one cable is neededjbr
a nonstereo VCR).
NOTE: The cables are not supplied with your TV.
You should be able to buy them at most stores
that sell electronics. Or you can call our
Customer Care Center at 1-800-531-0039.
Connect a cable TV or antenna signal to
the ANT IN jack on the rear of the VCR.
Connect from the OUT jack on the rear
of the VCR to the ANTENNA IN 75D
jack on the rear of the TV.
Connect the VIDEO OUT jack on the
rear of the VCR to the INPUT AVI
VIDEO jack on the rear of the TV.
Connect the audio output R(ight) and
L(eft) jacks on the rear of the VCR to the
INPUT-AV 1AUDIO jacks on the rear of
the TV.
NOTE: if the VCR is a mono (nonstereo)
unit, connect only the left audio cable,
which usuallyhas a white connector.
Press the AV button on the remote con-
trol as many times as necessary to select
the AV1 source for the viewing of materi-
als from your VCR.
Rear of VCR*
* (Example: Philips VCR
model VR674CAT)
[]
Rear of TV
Coaxial Cable
Lead-in from
C_ble TV Company
or VHF/UHF Antenna
Stereo sound will pass from the ANT
OUT jack on the VCR to the ANTENNA
IN 75_ jack on the TV only when the
VCR is in TV mode. This is the mode
that allows the TV to use its channel
selector.
To simplify making connections, audio
and video cables often have color-coded
plugs. The jacks on your TV are likewise
color coded to match the plugs. The cod-
ing is as follows:
--Yellow for video (composite)
--Red for the right audio channel
_hite for the left audio channel
NOTE: If your VCR is mono (non-
stereo), you will connect only one audio
cable. You must ensure that the TV is set
to MONO for the sigual source to which
you've connected the VCR (INPUT-AV 1,
INPUT-AV2, or the side panel inputs
[AV3]). Otherwise, you will receive
sound from only one of the TV's speakers.
See page 38.
You can display the AV 1, AV2, or AV3 signal
sources in the PIP window. See page 8 of the
Quick Use and Setup Guide for information on
using the Picture-in-Picture (PIP) feature.