Philips 55PW9383 Directions For Use Manual page 19

NOdW that you have looked up the [bur-
igit remote-control Direct-entry Code
ibr your brand of accessory device you are
ready to jbllow the simple steps shown below
to program your TV remote.
Please read through all the steps before
beginning.
2
First, press and hold down the VCR
or ACC (for an accessory device
other than a VCR) mode button on
the TV remote. Then press and hold
down the MENU/SELECT button at
the same time for a brief moment.
Release the buttons. The TV remote
back light will switch on.
NOTE: For correct operation, you
must first press and hold the mode
button and then press and hold the
MENU/SELECT button simultaneously.
Within 30 seconds of pressing the
VCR (or ACC) button and
MENU/SELECT button, enter a
four-digit code for the accessory
device (see pages 21 and 22).
if you make a mistake while attempt-
ing to enter the four-digit code and
want to start again, press any button
other than one with a nmnber. Then
return to step 1 to begin again.
Point the remote at the accessory device. Then press the POWER button
on the remote to tuna the device on.
If you do not enter a complete code within
30 seconds, you will need to perform step
1 of the Code-entry Method again.
If you enter more than four digits, the unit
will retain the first four digits entered.
If the procedure explained above does not
work the first time, repeat the steps using
the same remote code nmnber.
• If after a second try the remote does not
operate your accessory device, and more
code nmnbers are listed for your brand,
use the next listed code number.
• If after repeated attempts the Entry-code
Method does not allow you to work your
accessory device with your TV remote, try
the Search Method explained on the next
page.
19
Using the Remote Control
Satellite Receiver
CaNe Converter Box
DVD Player
Imm_m_m m_mnmnm I
VCR
®@@
@@@
®@@
PHILIP$