Advertisement
OwUr T V remote can be set to
ork your VCR or Cable
Converter
by what is called the
SEARCH
method
If the "REMOTE
CODE"
number
method shown
in the previous
sec-
tion di d not set your remote to
work your VCR or Converter,
then
fi)llow the easy steps listed below.
Please read through
steps 1-4
before
beginning.
1_
Press the
on
POWER
button
I the VCR or Converter
to turn the
unit ON.
_,
Stand at
away
least six feet
fi'om the front of the VCR or
Converter.
Point the remote
toward the unit.
HOLD
DOWN
the SURF
and the
desired
System
(VCR or CBL-
C,onverter)
buttons
at the same
time. KEEP HOLDING
BUT-
TONS DOWN.
the Channel
Indicator
Watch
on the unit.
I Channel
Numbers
will SCAN UP
when the unit has been identified.
This may take up to two minutes.
4_
Release the SURF and System
(VCR
or CBL) buttons
as soon
as channel
numbers
start to scan
up. The code has been identified
and the remote
is ready to operate
with the VCR or Converter.
Remember, a minute or
two can seem very long, but
the code should be located within
two minutes.
Don't let the VCR scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search
cycle will have to be repeated.
If no channel change happens
within two minutes, repeat steps 1-
4. Should a channel change still
not occur, the remote will not
work with the desired unit.
CABLE CONVERTER
Don't let
.... ,_,_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!iiiiiiiiiiiiiiiiiiiiiiiiiiiii_:_
9
li]iii::i_,_
....
o91
T
Six Feet
(minimum)
Advertisement
