Advertisement
J
See the aboveinformation on
how to use theLocatorCode
ButtonforProgramming.
17
<
For most homes this step would
not be needed but for your
information:
Up to 9 different
remote locator
address
codes can be set on which the
TV can send out its "homing" signal.
This is done in case there is more than
one TV (with a remote locator)
present,
and you want only one
specific remote to be signaled
when the
TV is turned ON.*
To set a Locator
Address
Code:
._
With TV turned ON, press the 'IV
System button first and then the
LOCATOR
CODE button on the
remote.
You will need a pencil or pen to press
the recessed button.
The TV shows the present Remote
Locator Code.
,_
Press
number button (0-9) or
any
the remote to set or change the Locatt
Code.
The remote will beep to let you know
it has received the new I_z_ator Code
and then return to its normal operating
mode.
l_
Remember, if batteries are replaced the
Locator Code will need to be
reentered.
When setting the Locator Code if any
button, other than the number buttons,
are pressed the remote will return to its
normal operation mode.
*For owners who live in an apartment
(townhouse or condominium)
complex, this task may be necessary
since the remote locator's signal can be
sent and detected directly through
adjoining walls.
Advertisement
