Cooktop Surface Light And Starter; Upper Oven Light - GE JHP56 Use And Care Manual

Hi-low cooking center
Hide thumbs Also See for JHP56:
Table of Contents

Advertisement

ooktop Surface Light and Starter
CAUTION: Do not touch the bulb when it is hot or
with wet hands.
Never wipe light area with a wet
cloth. Interrupt
electrical
supply to the cooking
center before
removing.
To replace
the bulb:
1. Remove the retaining panel (remove 3 screws)
securing the top of the light glass panel.
2. Carefully pull the light glass out by the top edge,
lifting it upward and out of the lower slot.
NOTE: You may need to carefully ply fork tines
behind the glass m loosen it. Do not exert force on the
glass alone_l
7 at the end trims.
3. Grasp the bulb firmly near each end and pull it
straight out.
4. Replace the bulb with one of the same length and
wattage.
5. Slip the light glass with the end trims back into the
lower slot.
6. Push the light glass upright and replace the upper
retaining panel and the three screws.
To replace the starter:
1. Remove the light glass as explained above.
2. Grasp starter, turn it counterclockwise,
about
1/4 turn, and lift out. Replace with one of the
same wattage.
3. Reposition the light glass as explained above.
,,_
Upper Oven
Cooktop
D, ,1_,
__
Retaining
--
Panel
-- --Light
Glass
:
Starter
/
Jpper Oven Light
Before replacing
the bulb, disconnect
electric power
to the cooking center at the main fuse or circuit
breaker panel or unplug the cooking center from the
electrical outlet. Let the bulb cool completely before
removing it. For your safety, do not touch a hot bulb
with a damp cloth. If you do, the bulb will break.
To remove, hold the glass cover and remove the
screw. Pull the glass cover fopa_ard, then down and
remove. Replace bulb with 40-watt appliance
bulb.
After replacing
bulb, tuck extension on glass cover
into back of light opening. Fit the cover over the
opening and replace the washer and screw. Then
connect electric power to the cooking center.
NOTE:
When removing
and replacing light cover,
if thermostat tube should be moved out of place, be
certain to return it to its proper horizontal
position,
and about 1/2 inch from cover.
(eot_tinued
next page}
i
27

Advertisement

Table of Contents
loading

Table of Contents