GE 25 Owner's Manual And Installation Instructions page 11

About the automatic icemaker,
www.GEAppliances.com
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
Power
Switch
Icemaker
Green
PowerLight _rArm
The icemaker will produce seven cul)es
per cycle>--al)l)roxilnately 100- 130 cubes
in a 24-hour period, depending on fl'eezer
cot/lpai'ttllent tet/tpei'attti'e_ i'oot/t
temperanu'e, number of door openings
and other use conditions.
See below tor how to access ice and reach
the power switch on dispenser models.
If the refl_igerator is operated befin'e the
water cmmecfion is made to the icemaket,
set the power switch in the 0 (off) position.
When the refl-igerator has been connected
to the water sui)i)ly, set the power switch to
the I (On) position.
The icemaker will fill with water when it
cools to ]5°F (-10 °C). A newly install ed
refi-igerator
may take 12 to 94 hours to begin
making ice cubes.
You will hear a buzzing sound each dine
the icemaker fills with water:
Throw awm the first tew batches of ice to
allow the water line to cleat:
Be sm'e nothing interteres with the sweep
of the feeler amt.
When the bin fills to the level of the teeler
am_, the icemaker will stop producing
ice. It is nomml tin" several cubes to be
joined together:
If ice is not used fl'equenfl> old ice cubes
will become cloudy, tasm stale and shrink.
NOTE."In homes with lower-than-averagewater
pressure,you may hear the icemakercycle multiple
times when making one batch of ice.
Models without a sheff
above the ice bin
Toaccessice andreach the
icemakerpower switch:
o Lift flTebin, then pull it
forward until the bin stops.
Lower the bin to access ice
or reach the power switch.
NOTE:In order to take furl advantage
of the tilt-out ice bin, only store items
on the shelf below the ice bfl7 that
are no taller than the Iowest point
on the bin.
Accessing Ice and Reaching the
Power Switch on Dispenser Models
There are two types of ice storage bins on
dispenser models. One has a shelf above
the bin, the other does not.
Special note about dispenser models
without a shelf above the ice bin:
These models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself
u I) while you take ice out or tm'n the
icemaker
power switch on and ofl_
Be sm'e to put the bin back in place
betore closing the (loot:
{' To restore your ice level from an empty
bucket stage, the following steps are
recommended:
12 horn's atter the first batch ofice
has fifllen into the bin, dispense
3 to 4 cubes.
@ After an additional 6 horn's, dispense
3 to 4 cubes again.
These steps will restore yore" ice lexel
in the shortest amount of time.
Models with a shelf
above the ice bin
To access ice, pull the bin forward.
ii _ii
ii
i _ilii
Toreach the power switch, pull the
shelf straight out Always be sure to
replace the shell
11