Flashing Display I,Ights; Using The Dishwasher - GE GSD4500 GSD4800 Owner's Manual

Flashing displaylights.
Lights What It Means What ToDo
This is hernial. Allow the dishwasher to drain and reset before you start a new w_tsh cycle.
The
SrARr/nESET
pad
has been pressed.
CLEAN
Control Error
Press the START/RESETpad t o turn off the beepe_. If the CLEANlight continues
to flash, c_dlfor service.
PLUSA
BEEPING
SOUND
PLUSA
BEEPING
SOUND
Control Error
Press the START/RESETpad to mrn off the beeper and the dishwasher will
attempt to reset. Then restart the wash cycle. If this error continues, call for
seI_qce.
Usingthe dishwasher.
Check t he WaterTemperature
The enmIing wamr must be at least 120°F and
not more than 150°F for effective cleaning and m
prevent dish damage. Check the wamr mmperamre
with a candy or meat thermometeL Turn on the
hot wamr faucet nearest file dishwasheI; place
the themlomemr in a glass and let the water run
continuously into the glass until the temperature
stops rising.
6
UseJet-Drg® RinseAgent
Jet-Dry _ rinse agent removes spots and prevents new film buildup on your dishes, ,glasses,
flatware, cookware and plastic.
Filling the Dispenser
Fill the rinse agent dispenser until it reaches the bottom
of lip inside the opening. Replace cap.
To check if rinse agent is needed:
On some models, remove the cap and look into the
dispenseL
On some models, press the clear cenmr of the fill cap
2 or 3 times. If _inse agent fills the cenmr of the cap,
you have enough.
A full dispenser shouldlast about one month.
If rinse agent spills, wipe up the excess.