Remote Control - Fisher PC-25S00, PC-27S90 Owner's Manual

QuickTips
Point the remote
control toward the
TV. Objects between
the remote control
and the TV may
cause misoperation
of the remote control
function.
T his remote control
has glow-in-the-dark
Power, Channel and
Volume keys.
Be sure batteries are
installed correctly.
If you cannot select
channel with number
keys. Press "0" in
front of numbers
1 ~ 9. Example:
Channel "05."
The "C" in front of
number on your
screen indicates a
Cable channel.
Adjusting the volume
level: Right flashing
arrow indicates
volume is increasing,
and left flashing
arrow indicates
volume is decreasing.
Channel number
will not display
continuously when
captioning is on.
Using V-Guide
TV Parental Guide-
lines settings can
be changed only
by using the

Remote Control.

(See pages 12 and 13.)
6
REMOTE CONTROL KEYS
Point towards TV
VIDEO
POWER
MODE
1 2
4 5
7
8
CAPTION
0
MENU
VOL
CH
MUTE
V-GUIDE
Video Mode Key
Press to select the program source to
be displayed on the screen: TV signal
or signal from the equipment you have
connected to the A/V jacks.
Power Key
Press to turn TV on or off.
Number Keys
Two keys must be pressed to select a
channel. Example: Press 0 then 6 to
select channel 6. For cable channels
100 through 125, press and hold the
1 key until C C C C 1 1 – – – –
1 1 – – – – appears. Then press
the other two numbers.
RESET
3
6
9
SLEEP
RECALL
11
VOL
DISPLAY
12
11
12
Caption Key (See page 10.)
Menu Key
Use this key with the /
/ keys to navigate and adjust
features of the on-screen menu system
(see pages 7 and 8).
Channel (CH / ) and
Volume (VOL / ) Keys
Press to scan through the channels in
memory or to adjust the volume.
Mute Key
Press once to turn off the volume.
Press again to restore.
Note: When using the audio out jacks
this key will not mute the sound.
V-Guide Key (See pages 11 ~ 13.)
Reset Key
Press this key twice to restore factory
settings. The TV will automatically
start Channel Search and clear all
customized settings. (See page 14.)
Sleep Key
Use this key with the "0" key to set the
Sleep Timer (see page 13).
Recall Key
Select a channel then select another
channel using the number keys. Press
Recall to switch between the channels.
Display Key
Press once to display the Channel
number. Press twice to display the
channel number continuously. Press
again to remove the display.
and