Advertisement
_e.com
D
Options
The light above the selected pad wi!! be ON to indicate which OPTION has been selected.
HOT START
(on some
models)
For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
selected PRIORto starting the cycle. This option wi!! improve both wash and dry
performance. This option adds 20 minutes to the cycle time.
NOTE:Cannot be selected with RINSEONLY cycle.
HEATEDDRY
Shuts off the drying heat option. Dishes air dry naturally and energy is saved.
Light OFF
For faster air dry you can prop the door open after the CLEAN light illuminates.
HEATEDDRY
Turns the heater on for fast drying. This will extend the total run time by 38 minutes.
Light ON
NOTE: Cannot be selected with RINSEONLY cycle.
LOCK
(on some
models)
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidenta!!g
start dishwasher
bg touching
pads with this option
selected.
To LOCKthe dishwasher control, touch and hold the HEATEDDRYpad for 3 seconds. The light below
the HEATEDDRYpad will turn on. To UNLOCKthe dishwasher control, touch and hold the HEATED
DRYpad for 3 seconds. The LOCK light will turn off.
HOT WASH
When selected, the cycle will run longer with the heating element on to improve both
wash and dry performance. NOTE: Cannot be selected with RINSEONLY cycle.
DELAYHOURS You can delay the start of a wash cycle for 2, 4 or 8 hours (delay time options may
vary by model). Touch the DELAYHOURS pad to choose the number of hours you want
to delay the start of the cycle; then touch START/RESET one time. The dishwasher will
count down and start automatically at the correct time. Touching START/RESET a
second time will cancel the DELAYSTARTselection.
RESET
To change a cycle after washing starts, touch the START/RESET pod to cancel the
cycle. The START/RESET light will flash while the water is pumped out if needed. This
takes approximately 90 seconds. When the light stops flashing, the dishwasher can be
reprogrammed and restarted.
B
Start
Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the
START/RESET pod once to begin the cycle. Water begins to fill the dishwasher, and approximately 60
seconds later the wash action begins. Touching the START/RESET pod a second time will cancel the
cycle and cause the water to drain out. This will take approximately 2 minutes.
NOTE:The dishwasher remembers your last cycle so you don't hove to reprogram each time. When
the dishwasher door is fully closed, the control panel lights will display the last settings you selected.
If you don't want to change any of the settings, simply touch the START/RESET pad once to begin
the cycle.
If the door is closed, the indicator lights will turn off if the START/RESET pad is not pressed within two
minutes. To activate the display, open and close the door or touch any pad.
Also, if a power failure occurs, NORMAL and HEATEDDRY will automatically
be programmed.
7
Advertisement
