Advertisement
Available languages
Available languages
Loading and using the dryer.
Always follow the fabric manufacturer's care label when laundering.
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for the
Do not overload. This wastes energy and causes
washer,they are sorted properly for the dryer,
wrinkling.
Do not add fabric softener sheets once the load has
become warm. They may cause fabric softener stains.
Bounce®Fabric Conditioner Dryer Sheetshave been
approved for use in all GE Dryerswhen usedin
accordance with the manufacturer's instructions.
Do not dry the following items: fiberglass items,
woolens, rubber-coated items, plastics, items with
plastic trim and foam-filled items.
Careand Cleaning of the Dryer
The Exterior'. Wipe or dust any spills or washing
compounds with a damp cloth. Dryer control
panel and finishes may be damaged by some
laundry pretreatment soil and stain remover products.
Apply these products away from the dryer. The fabric
may then be washed and dried normally. Damage to
your dryer caused by these products is not covered
by your warranty.
The Lint Filter: Cleanthe lint filter before each
use. Moisten your fingers and reach into the filter
opening. Run your fingers acrossthe filter. Havea
qualified technician vacuum the lint from the dryer
once a year.
J
Stainless Steel: To clean stainless steel surfaces,
use a damp cloth with a mild, non-abrasive cleaner
suitable for stainless steel surfaces. Remove the
cleaner residue, and then dry with a clean cloth.
The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a gear to prevent clogging.
A partially clogged exhaust can lengthen the
drying time.
Follow these steps:
r_ Turn off electrical supply by disconnecting the
plug from the wall socket.
-2-]Disconnect the duct from the dryer.
r_-] vacuum the duct with the hose attachment and
reconnect the duct.
TheExhaust Hood: Checkfrom the outside that the
flaps of the hood move freelg when operating. Make
surethat there is not wildlife (birds,insects,etc.)nesting
insidethe duct or hood.
10
Advertisement
