GE Appliances AG_18 Owner's Manual And Installation Instructions page 5

www.GEAppliances.com
When the air conditioner is turned on, it will
automatically start in the last cool and fan
settings used.
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
COOLMode
Use the #00L mode _dth HIGH(F3), M ED (F2)or
LOW(FIt tin1fi)r cooling. Use the INCREASE&/
OECREASEV pads to set the desired temperature
belween 60°F and 86°F in 1°F increments.
A thermoslat is used to maintain the room
temperature. The compressor will (ycle on and off
to keep the room at the set level of comfi)rt. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE." f f the air conditioner is off and is then turned on
while set to COOL, it will take approximately3 minutes
for the compressorto start and cooling to begin.
Cooling Descriptions
ForNormal Cooling-Select the COOL mode and
HIGH (13) or MED(F2)tim with a middle set
temperature.
ForMaximum Cooling-Select the COOLmode
and HIGH(F3)tim with a lower set temperature.
ForQuieter& NighttimeCooling-Select the
COOL mode and LOW(FIttim with a middle
set
temperature.
NOTE." If you switch from a COOL setting to OFFor to
a fan setting, wait at least3 minutesbefore switching
back to a ¢00L setting.
FAN Mode
Use the FANat HIGH(F3),MED (F2)or LOW(FI) to
pr_)dde air circulation and fihering without cooling.
Since tan only settings do not pro)vide cooling,
a temperature setting will not be displayed.
Vent Control
The vent conuol is located on the inside of the air
louvers on the htwer right side.
When set at CLOSE, only the air inside the room _dll
be circulated and conditioned. When set at OPEN,
some inside air is exhm_sted outside.
To open the vent, pull the lever toward you.
To close it, D_sh it in.
A# Direction - Up and Down
Fingertip pressure on the bank of horizontal louvers
at!justs the air direction up or down.
5