Burner Caps And Heads - GE monogram ZGU36K Owner's Manual

Burner caps
and heads
NOTE: Before removing the burner caps and
heads, remember their size and location.
Replace them in the same location after
cleaning. The burner heads and burner bases
are labeled B, C 0 and H to aid reassemblg.
Burner caps
Lift off when cool. Wash burner caps in hot,
soapy water and rinse with clean water. You
may scour with a plastic scouring pad to remove
burned-on food particles.
Burner heads
The slits in the burner heads of your cooktop
must be kept clean at all times for an even,
unhampered flame.
You should clean the burner caps, burner heads
and burner bases routinely, especially after bad
spillovers, which could clog the openings in the
burner heads. Lift off when cool.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent and
hot water for 20-30 minutes. For more stubborn
stains, use a toothbrush.
After cleaning
Before putting the burner caps and heads back,
shake out excess water and then dry them
thoroughly by setting in a warm oven for 30
minutes.
Replacement
The burner heads and burner bases are labeled
B, C, D and H to aid reassembly.
Medium Small Small
head and head and head and
Large Extra large
head and head and
cap cap
Replace the burner heads on the
bases matching the letters. Replace the caps on
the heads. Make sure that the caps and heads
are replaced in the correct location. There are
two small (H), one medium (B),one large (C)and
one extra large (D)head and cap.
pins
Pin
When replacing, make sure the Iocator pins in the burner
head are seated in the pin slots of the burner base. Rotate
the burner head around the burner base until it is level and
securely seated.
15