GEAppliances.com
INSTALLINGTHESTACKBRACKETKIT
1. Remove
the Dryer
Leveling
Legs
A°
B°
Carefully lay the dryer on its side.
Use the packing material so you
don't scratch the finish on the dryer.
Use an open-end wrench or pliers
to remove the dryer leveling legs.
2. Install
Rubber
Pads
to Dryer
Base
Locate the/4 rubber pads in the parts
package. Remove the adhesive backing
and firmly place over on the bracket
where you removed the leveling legs.
3°
A°
B°
Install
Bracket
to Dryer
Align the holes in the left bracket
with the holes in the bottom left
corner of the dryer. Use a Phillips
screwdriver to install the 2 #12 x 1"
tapping screws.
Repeat the above step with the right
bracket on the bottom right corner
of the dryer.
C. Set the dryer upright.
NOTE: Hake sure to set the dryer
on a piece of packing material so
the brackets that are attached to
the bottom of the dryer do not damage
the floor.
21