GE Appliances Next Step Control Owner's Manual page 6

Using the surface units,
[,A WARNING
i IRE HAZARD: Never leave the range unattended with the cooktop on medium or high settings. Keep flammable items away from the cooktop. Turn off all controls when
done cooking. Failure to follow these instructions can result in fire, serious injury or
death.
Throughout this manual, features and appearance may vary from your model.
The power level with a fraction
indicates the additional
half-step setting. You may
hear clicking sounds indicating
the control is maintaining your
desired setting.
Surface Unit Cook Settings
The cooktop offers 19 power levels.Power
levels range from "L"to HI in precise half-step
increments. For example: 1,1-1/2, 2, 2-1/2 and
up to HI.
Power Level"L",the lowest setting, is
recommended for "KeepWarm."
The power level increases one-half levelwith
each touch.
NOTE:When changing from a high heat setting
to a lower heat setting, the surface unit may
stop glowing. This is normal. Theunit is still on
and hot.
NOTE:This cooktop has a rapid heat-up feature.
If the cooktop is cool when turned on, it will
glow red for a short period of time until the
desired power setting is reached.
, iiiiiiiiiiiii
iiiiiiiiiii_iiii!iiii!iiiiiiiiiiiiiiiiiiiii_iii _i_lil_l_l_l_l_iil_i_i_il_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii\_ ...................................... _-J iiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiL
Single Surface Unit--Cook Settings
To turn on a single surface unit:
[Z] Touch the ON/OFF pad; then touch the
(+)/(-)pad.
[] Use the (+)/(-) pad to choose the desired
power setting.
To use the Melt feature:
Touch the ON/OFF pad; then touch MELT.
The element will automatically set to a
predetermined setting and "L" will be displayed.
To turn off a single surface unit, touch the ON/
OFF pad again.
To use the Simmer feature:
Touch the ON/OFF pad; then touch SIMMER.
The element will automatically set to a
predetermined setting and "3" will be displayed.
Adjust using the (+)/(-) pad to increase or
decrease the simmer rate.
Multi-Ring Burner (con be dual or triple, depending on model)
[-_ Touch the ON/OFF pad for the right-front
surface unit.
Use the (+)/(-) pad to set the desired power
setting.
rJ] Touch the BURNERSIZEpad us needed to
select the desired burner size.
The light next to the BURNERSIZEpad
indicates which size the surface unit is on.
To turn the surface unit off, touch the ON/OFF
pad.
See page 10 for additional information.