Table of Contents
Advertisement
Throughthe Wall Installation Instructions-OptionaL
The case may be installed throughthe wall in bothexisting and new construction.
Read completely, then follow step-by-step.
IMPORTANT
I
Throughthe wall installation is not appropriate
if any of theside louvers in the case will be
obstructedby the wall.
All side louvers in the case mustproject on the
outdoorside of the wall.
The roomside of the case mustproject into the
roomat least 13/g" from the finished wall.
The case mustbe installed level from side-to-side
and with a slight tilt fromfront to rear. Usea level;
abouta 1/2bubblewill be the correctcaseslant to
theoutside.
i
i
[]Remove
the air conditioner
from the case.
I I
For specific instruction,
refer to the Window
'
InstallationInstructions.
[]Make
certain a walt receptacle
is available
close to the hole location or make
arrangements
to install a receptacle.
[]Place
the case in the wall opening
and secure
with 12 1" long # 10 wood screws.
NOTE:Drill pilot holes, if necessary, for proper
installation. If the frame is oversized, use shims
to prevent case distortion.
Finish the Wall Open&g
Caulk all four sides on the outdoor
side of the case to prevent moisture
from getting through
to the
interior
walt. Use of flashing (drip rail) will further
prevent water from dripping
inside the wall and
down the outside of the building.
Piaster line
Lintel angle (tt required) _
I _//
Caulking
f%---_-_ I
Trim molding (if desired)
OUTSIDE
Air louvers
(must project on
the outdoor side
of the wall,)
INSIDE
.I Bottom rail
Wood Filler and Caulkin,
(above & below the flashing)
Flashing (Drip rail)
4,5
cm (1314")
min.
12
Advertisement
Table of Contents
