Wiring; Wiring For The Optional Fan Kit; Removing And Installing The Door - Montigo L42DF series Installation & Operation Manual

f i r e f e a t u r e

Wiring

Gas Control and Pilot Wiring
Honeywell (Q3450)
Pilot Assembly
Gas Control
Connector
Fan Plug
Receptacle
Gnd Screw
Wall Switch
Figure 26.
Wiring for the L42DF-I with Honeywell gas control and pilot.

Wiring for the optional Fan Kit

The L42DF fireplace may be equipped with optional fan kits for circulating
heat into the living space.
Installations in Canada which employ the fans must be electrically
grounded in accordance with CSA C22.1 Canadian Electrical Code
Part 1 and/or Local Codes.
Installations in the USA which employ the fans must be grounded in
accordance with local codes or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70-1987.
For more information see the Fan Kit Installation Guide included with
the fan kit.
NOTE: If any of the original wire supplied with the appliance is replaced, it
must be replaced with the same type, or its equivalent.
5/1/60 Supply
G L1 L2
Quick Connect
Figure 27. Wiring schematic for optional fans.
Part No. XG0181 - 081009
Installation
Pilot Electrical
Harness Connector
Honeywell Gas
Control (SV9501M)
Junction Box
115VAC
24VAC
40 VA
Transformer
L2-WH
G
L1-BLK
p g lu to motor
Removing and Installing
Removing the door:
The doors are removed in a few simple steps. Follow the Steps shown to
remove the Horizontal access panel, unlatch the door buckles, remove
the door, then replace in reverse order.
Step 1:
Remove the Horizontal Access Pan
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushng away from
you and lifting out. Place it
aside during maintenance or
cleaning.
Black
White
Install in reverse order.
Green
Figure 28. Removing and installing the the Horizontal Acess Panel
Locate the Door Buckles:
Step 2:
Figure 28a. Loccate the door buckles. (Both Sides Typical)
Release the Door Buckles
Step 3:
Hand-hold
Figure 28b. Door buckle Tool
Step 4:
Firmly grasp hand-hold
end of tool and place the
machined end in the slot
under door frame. (as
shown)
Figure 28c.
L42DF Flush Indoor Gas Fireplace
the Door
Finger Holes
Installed Gas
Valve Cove r
Door Latch Slot
Door Latch Hook
1
el:
Page 15